Seat Back Recliner Replacement - Front

SEAT BACK RECLINER REPLACEMENT - FRONT

REMOVAL PROCEDURE
1. Remove the seat.
2. Remove the seat back frame.
3. Remove the seat cushion.




4. Disconnect the recliner motor electrical connectors.
5. Remove the seat axle retainers (3).
6. Pull the seat track sides apart in order to separate the seat track sides.
7. Remove the nuts (1) securing the recliner to the seat track.

INSTALLATION PROCEDURE




1. Install the nuts (1) securing the recliner to the seat track.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nut to 65 N.m (18 lb ft).
2. Locate the axles and the seat position drive cable (2) in order to connect the seat track sides.

IMPORTANT: Insure that the seat position motor cable is fully seated into the drive gear.

3. Install the seat axle retainers (3).
4. Connect the recliner motor electrical connectors.
5. Install the seat cushion.
6. Install the seat back frame.
7. Install the seat.
8. Calibrate the seat. Refer to Memory Seat Calibration .