Seat Back Replacement - Rear

SEAT BACK REPLACEMENT - REAR

REMOVAL PROCEDURE
1. Remove the upper trunk trim.

CAUTION: Refer to SIR Caution in Service Precautions.




2. Remove the upper retaining nuts (1) from the rear seat back.
3. Remove the rear seat cushion.




4. Remove the center seat belt (2) and shoulder belt buckle nut (1), if equipped.
5. Place the center shoulder belt on the rear shelf panel.




6. Remove the lower seat back retaining nuts (1).




7. Pull out on the top of the rear seat back.
8. Position the rear shoulder belts to clear the rear seat back during removal.
9. Remove the rear seat back.

INSTALLATION PROCEDURE




1. Install the rear seat back into the car.




2. Install the upper retaining nuts (1) to the seat back studs (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 9 N.m (80 lb in).
3. Install the upper trunk trim.




4. Install the rear seat back retaining nuts (1).

Tighten the nut to 9 N.m (80 lb in).




5. Install the center seat belt (2) and shoulder belt buckle anchor nut (1).

IMPORTANT:
- Ensure that the bolt threads and bolt holes are free of any sealer patch material.
- Ensure the seat belt buckles are properly positioned.

Tighten the bolts to 30 N.m (22 lb ft).
6. Install the rear seat cushion.