80. Engine Valley Cover Installation

Engine Valley Cover Installation





1. Important: All gasket surfaces should be free of oil or other foreign material during assembly.

Lubricate the O-ring seals (537) with clean engine oil.
2. Install the O-ring seals (537) to the cover.





3. Notice: Refer to Fastener Notice.

Install the cover (555), gasket (556), and bolts (506).
^ Tighten the cover bolts to 25 Nm (18 ft. lbs.).





4. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent, to the threads of the sensor.
5. Install the oil pressure sensor (706) and sealing washer (707).
^ Tighten the sensor to 20 Nm (15 ft. lbs.).