Blower Motor Control Processor (RHD)

BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT (RHD)

REMOVAL PROCEDURE
1. Remove the left closeout panel.




2. Disconnect the electrical connector (1) from the blower motor control processor.




3. Remove the blower motor control processor retaining screw (1).




4. Remove the blower motor control processor from the vehicle.

INSTALLATION PROCEDURE




1. Install the blower motor control processor.




2. Install the blower motor control processor retaining screw (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 1 N.m (9 lb in).




3. Connect the electrical connectors (1) to the blower motor control processor.
4. Install the left closeout panel.