Operation CHARM: Car repair manuals for everyone.

Fuel Pump Electrical Circuit Diagnosis



FUEL PUMP ELECTRICAL CIRCUIT DIAGNOSIS

CIRCUIT DESCRIPTION
When the ignition switch is turned ON, the control module energizes the fuel pump relay which applies power to the in-tank fuel pump. The fuel pump relay will remain on as long as the engine is running or cranking and the control module is receiving reference pulses. If no reference pulses are present, the control module de-energizes the fuel pump relay within 2 seconds after the ignition is turned ON or the engine is stopped.

DIAGNOSTIC AIDS
Listen for an audible hiss from the fuel pump when the fuel pump relay is commanded ON. A vibration in the fuel feed line when the fuel pump relay is commanded ON indicates that the fuel pump is operating.

For an intermittent condition, refer to Testing for Intermittent Conditions and Poor Connections. Component Tests and General Diagnostics

TEST DESCRIPTION

Step 1 - Step 13:




Step 14 - Step 22:




The numbers below refer to the step numbers on the diagnostic table:
2. This step verifies that the fuel pump operates.
3. This step determines if the condition is located on the coil side or the switch side of the circuit.
7. This step tests for a grounded voltage supply circuit.
9. This step verifies that the fuel pump fuse is providing voltage to the fuel pump relay.
15. This step tests for an intermittent condition between the fuse and the fuel pump.