Park Brake Cable Replacement - Right Rear (J55)

Park Brake Cable Replacement - Right Rear (J55)

Tools Required
^ J37043 Parking Brake Cable Release Tool

Caution: Refer to Brake Dust Caution in Service Precautions.

Removal Procedure
1. Raise the vehicle and suitably support.
2. Remove the rear tire and wheel assembly.





3. Pull down on the intermediate park brake cable (2) near the park brake cable connector (1).
4. Disconnect the intermediate park brake cable (2) from the park brake connector (1).





5. Disconnect the right rear park brake cable (2) from the intermediate park brake cable connector (3).
6. Using J37043, press the right brake cable locking tabs (2).
7. Remove the right park brake cable (2) from the park brake cable support bracket (1).





8. Using J37043, press the right park brake cable locking tabs.
9. Remove the right park brake cable (2) from the caliper park brake cable bracket (1).
10. Disconnect the right park brake cable (2) from the park brake actuator lever (3).
11. Remove the right park brake cable (2) from the vehicle.

Installation Procedure





1. Install the right park brake cable (2) to the park brake cable support bracket (1).
2. Press the right park brake cable into the park brake cable support bracket (1). Ensure that the locking tabs are properly seated.
3. Connect the intermediate park brake cable connector (3) to the right park brake cable (2).





4. Connect the right park brake cable (2) to the park brake actuator lever (3).
5. Install the right park brake cable (2) to the caliper park brake cable bracket (1). Ensure that the locking tabs are properly seated.





6. Pull down on the intermediate park brake cable (2) near the park brake cable connector (1).
7. Connect the intermediate park brake cable (2) to the park brake connector (1).
8. Install the right tire and wheel assembly.
9. Lower the vehicle.