108. Ignition Module Installation - Right Side

Ignition Module Installation - Right





Notice: Refer to Fastener Notice in Service Precautions.

1. Install the right spark plugs.
Tighten the spark plugs to 15 Nm (11 ft. lbs.).





2. Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984) to each spark plug boot (1) of the ignition coil assembly.





3. Install the ignition coil assembly.
4. Install the ignition coil assembly bolts (708) and ball studs (709).
Tighten the ignition coil assembly bolts (708) and ball studs (709) to 10 Nm (89 inch lbs.).





5. Install the ignition coil assembly sight shield cover.





6. If equipped, install the fuel injector sight shield bracket.
7. Install the fuel injector sight shield bracket bolts.
Tighten the fuel injector sight shield bracket bolts to 10 Nm (89 inch lbs.).