Drive Belt Replacement

Drive Belt Replacement

Removal Procedure





1. Install a 1/2 inch drive breaker to the drive belt tensioner.
2. Push down on the breaker bar in order to release the tension.
3. Remove the drive belt from the power steering pump.
4. Slowly return the tensioner to the original position.
5. Remove the belt.

Installation Procedure





1. Route the drive belt around all the pulleys except for the power steering pump and the drive belt tensioner.
2. Install a 1/2 inch drive breaker bar to the drive belt tensioner.
3. Push down on the breaker bar in order to release the tension and route the belt around the tensioner pulley.
4. With the belt around the tensioner pulley, route the belt around the power steering pump pulley. Ensure the belt is properly seated on all pulleys.
5. Slowly return the tensioner to its original position.
6. After drive belt installation, inspect the drive belt for the proper routing and correct alignment.
7. Start the engine and check for proper belt and accessory operation.