Battery Negative Cable Disconnect/Connect Procedure

Battery Negative Cable Disconnect/Connect Procedure

Removal Procedure





1. Caution: Refer to SIR Caution in Service Precautions.

Caution: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Important: The radio incorporates electronic memory for the clock and pre-selected radio stations, reprogramming is not necessary.

Ensure all lamps and accessories are OFF.
2. Ensure the ignition switch is in the OFF position.
3. Remove the rear seat cushion.
4. Loosen the negative battery cable bolt.
5. Separate the negative battery cable from the battery.

Installation Procedure

Important: Clean any existing oxidation from the contact face of the battery and battery cable using a wire brush prior to installing the battery cable to the battery.





1. Position the negative battery cable to the battery.

2. Notice: Refer to Fastener Notice in Service Precautions.

Tighten the negative battery cable bolt.
Tighten the bolt to 17 Nm (13 ft. lbs.).
3. Install the rear seat cushion.