78. Oil Pan Cleaning and Inspection

Oil Pan Cleaning and Inspection

^ Tools Required
- J 28410 Gasket Remover

Cleaning Procedure
1. Remove any old thread sealant, gasket material or sealant using J 28410 .
2. Clean the oil pan and oil pan components in solvent.
3. Clean out debris from the bolt holes.

4. Caution: Refer to Safety Glasses Caution .

Dry the oil pan and oil pan components with compressed air.

Inspection Procedure





1. Inspect the exterior of the oil pan for the following conditions:
^ Dents or damage to the exterior (1)
^ Damage to the drain plug or drain plug hole (2)
^ Damage to the transaxle brace mounting bosses (3)
^ Damage to the transaxle mounting bosses (4)





2. Inspect the interior of the oil pan for the following conditions:
^ Gouges or damage to the oil pan sealing surfaces (1)
^ Damage to the oil pan scraper mounting holes (2)
^ Damage to the bolt holes (3)
3. Repair or replace the oil pan and/or oil pan components as necessary.