Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake

CAMSHAFT POSITION ACTUATOR SOLENOID VALVE SOLENOID REPLACEMENT - BANK 1 (RIGHT SIDE) INTAKE

REMOVAL PROCEDURE




1. Turn the ignition OFF.
2. Remove the front compartment sight shields as necessary.
3. Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.

IMPORTANT:
- Do not remove the engine control module (ECM) from the ECM bracket.
- Do not remove the ECM redundant ground wire from the ECM.

4. Disconnect the camshaft position (CMP) actuator valve electrical connector.




5. Remove the CMP actuator valve bolt.
6. Remove the CMP actuator valve.
7. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.

INSTALLATION PROCEDURE
1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.




2. Install the CMP actuator valve.
3. Install the CMP actuator valve bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the CMP actuator valve bolt to 10 Nm (89 lb in).




4. Connect the CMP actuator valve electrical connector.
5. Install the ECM bracket with the ECM.
6. Install the front compartment sight shields as necessary.