Fog/Driving Lamp: Description and Operation

FRONT FOG LAMPS
With the ignition switch in the ON or START position, the front fog lamps will illuminate when the driver toggles the front fog lamp switch to the ON position. The front fog lamp switch is a momentary switch that requires the driver to briefly place the front fog lamp switch to the ON position and release it. The instrument panel module (IPM) controls the front fog lamp relay coil. When the driver toggles the front fog lamp switch to the ON position, the switch supplies ground to the front fog lamp switch signal circuit of the IPM. In response to this input, the IPM supplies ground to the front fog lamp relay control circuit. The underhood fuse block supplies battery positive voltage to the switch circuit of the front fog lamp relay. Ignition voltage is available to the front fog lamp relay coil when the key is in the RUN or CRANK positions. When the IPM grounds the front fog lamp relay control circuit the relay coil energizes, closing the switch contacts. Current then flows from the fog lamp fuse through the front fog lamp relay switch to both front fog lamps. Both front fog lamps are permanently grounded at G104. The front fog lamps will default to the OFF position upon a key cycle.

The IPM will turn the park lamps ON when the front fog lamps are ON and send a message via GMLAN serial data to the instrument panel cluster (IPC) to enable the front fog lamp indicator. The front fog lamps will deactivate when either the flash-to-pass or the high beam headlamps are turned ON. For vehicles exported to Japan or any European Country except Norway or Sweden, the front fog lamps will remain illuminated with the operation of the high beam headlamps or flash-to-pass.

REAR FOG LAMPS - EXPORT
Rear fog lamps are required equipment on some export vehicles. The rear fog lamps are located in the rear deck lid lamp assembly. The rear fog lamps will only operate when the ignition in the RUN or CRANK positions and either the front fog lamps or headlamps are turned ON. When the driver turns the rear fog lamp switch ON, the switch supplies ground to the rear fog lamp switch signal circuit of the instrument panel module (IPM). In response to this input, the IPM sends a message via GMLAN serial data to the rear integration module (RIM). The RIM responds to this message by grounding the rear fog lamp relay control circuit. When the rear fog lamp relay control circuit is grounded, this energizes the rear fog lamp relay coil causing the switch side contacts to close. Supply voltage from the rear fog lamp fuse flows through the rear fog lamp relay switch to the rear fog lamps. The rear fog lamps have permanent ground at G401. The IPM communicates via GMLAN serial data with the instrument panel cluster (IPC) requesting the rear fog lamp indicator be illuminated. The rear fog lamps will deactivate if the front fog lamps or headlamps are turned OFF, if the ignition is out of the RUN or CRANK position, or if the driver turns the rear fog lamp switch OFF. The rear fog lamps will default to the OFF position upon a key cycle.