Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake

CAMSHAFT POSITION SENSOR REPLACEMENT - BANK 1 (RIGHT SIDE) INTAKE

REMOVAL PROCEDURE




1. Turn the ignition OFF.
2. Remove the front compartment sight shields as necessary.
3. Disconnect the camshaft position (CMP) sensor electrical connector.




4. Remove the CMP sensor bolt.
5. Remove the CMP sensor.

INSTALLATION PROCEDURE




1. Install the CMP sensor.
2. Install the CMP sensor bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 10 N.m (89 lb in).




3. Connect the CMP sensor electrical connector.
4. Install the front compartment sight shields as necessary.