Fuel Tank Pressure Sensor: Service and Repair

FUEL TANK PRESSURE SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the fuel tank pressure sensor electrical connector (1).




3. Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.

IMPORTANT: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.

INSTALLATION PROCEDURE




1. Install the fuel tank pressure sensor to the EVAP canister until fully seated.

IMPORTANT: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.




2. Connect the fuel tank pressure sensor electrical connector (1).
3. Lower the vehicle.