Multifunction, Turn Signal Switch Replacement

Multifunction, Turn Signal Switch Replacement

Removal Procedure

1. Caution: Refer to SIR Caution in Service Precautions.

Disable the SIR system. Refer to Restraint System Disabling and Enabling Zone 3.
2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement.





3. Remove the retaining screws from the multifunction switch.
4. Disconnect the multifunction switch electrical connections.
5. Remove the multifunction switch.

Installation Procedure
1. Connect the multifunction switch electrical connectors.
2. Install the multifunction switch to the steering column.





3. Notice: Refer to Fastener Notice in Service Precautions.

Install the retaining screws to the multifunction switch.
Tighten the screws to 7 Nm (62 inch lbs.).
4. Install the steering column trim covers.
5. Enable the Restraint System.