Steering Column Tilt Head Replacement

Steering Column Tilt Head Replacement

^ Tools Required
- J 23653-SIR Steering Column Lock Plate

Removal Procedure

1. Caution: Refer to SIR Caution in Service Precautions.

Disable the SIR system. Refer to Restraint System Disabling and Enabling Zone 3.
2. Remove the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement (Coil).





3. Using J 23653-SIR remove the bearing retainer (1).





4. Remove the shaft lock shield assembly (1).
5. Remove the turn signal cancel cam assembly (2).
6. Remove the upper bearing spring (3).

Installation Procedure





1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).





4. Install the bearing retainer onto J 23653-SIR.
5. Using J 23653-SIR depress the shaft lock shield assembly.
6. Push the bearing retainer (1) into place.
7. Remove J 23653-SIR from the steering shaft.
8. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement (Coil).
9. Enable the Restraint System. Refer to Restraint System Disabling and Enabling Zone 3.