P0454
DTC P0454
CIRCUIT DESCRIPTION
The fuel tank pressure (FTP) sensor measures the difference between the air pressure or vacuum in the evaporative emission (EVAP) system and the outside air pressure. The control module supplies a 5-Volt reference and a low reference circuit to the FTP sensor. The FTP sensor signal circuit voltage varies depending on EVAP system pressure or vacuum. If the FTP sensor signal voltage goes above or below a calibrated value, this DTC sets.
The table illustrates the relationship between the FTP sensor signal voltage and the EVAP system pressure/vacuum.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
P0454 Fuel Tank Pressure (FTP) Sensor Circuit Intermittent
CONDITIONS FOR RUNNING THE DTC
The engine is running.
CONDITIONS FOR SETTING THE DTC
The fuel tank pressure sensor voltage is more than 4.95 or less than 0.045 volts for one second.
ACTION TAKEN WHEN THE DTC SETS
- The control module stores the DTC information into memory when the diagnostic runs and fails.
- The malfunction indicator lamp (MIL) will not illuminate.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
- The driver information center, if equipped, may display a message.
CONDITIONS FOR CLEARING THE DTC
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DIAGNOSTIC AIDS
The DTC is designed to detect an intermittent short to ground or a short to voltage on the FTP signal circuit. An open circuit on the 5-Volt reference, the signal circuit or the low reference circuit may also set this DTC.
TEST
