15. Crankshaft Balancer Removal

Crankshaft Balancer Removal

^ Tools Required
- EN 46106 Flywheel Holding Tool
- J 24420-C Harmonic Balancer Puller
- J 38416-2 Crankshaft Button





1. Install the EN 46106 through the starter mounting hole.





2. Remove the crankshaft balancer bolt.





3. Install the J 38416-2 in the nose of the crankshaft.





4. Install the J 24420-C in order to remove the crankshaft balancer.





5. Pull the crankshaft balancer off by tightening the center bolt on the J 24420-C until the crankshaft balancer pulls off of the crankshaft end.
6. Remove the J 24420-C from the crankshaft balancer.