Operation CHARM: Car repair manuals for everyone.

B0052



DTC B0052

DTC DESCRIPTORS

DTC B0052
Deployment Commanded

DTC B0053
Deployment Commanded with Loop DTCs Present

DIAGNOSTIC FAULT INFORMATION
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Testing and Inspection

CIRCUIT/SYSTEM DESCRIPTION
The inflatable restraint sensing and diagnostic module (SDM) contains a sensing device that converts vehicle velocity changes into an electrical signal. The SDM compares this electrical signal to a value stored in memory. When the generated signal exceeds the stored value, the SDM performs additional signal processing and compares the generated signals to values stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the deployment loops, deploying the air bags and/or pretensioners causing DTC B0052 to set.

CONDITIONS FOR RUNNING THE DTC
Ignition voltage is between 9-16 volts.

CONDITIONS FOR SETTING THE DTC

B0052
- The SDM detects a frontal impact of sufficient force to warrant deployment of the frontal modules.
- The SDM detects a side impact of sufficient force to warrant deployment of a side impact module and/or roof rail module.
- The SDM has deployed the seat belt pretensioner for 3 separate deployments.

B0053
SDM commands inflators deployment with loop faults present.

ACTION TAKEN WHEN THE DTC SETS
- The SDM will only set DTC B0052 or the SDM sets DTC B0053 along with DTC B0052.
- The SDM commands the AIR BAG warning lamp ON via serial data communications.
- The SDM records crash data.

CONDITIONS FOR CLEARING THE DTC
DTC B0052 can be cleared if the following conditions are met.
- Three consecutive seat belt pretensioner deployment events have not occurred.
- One frontal or side air bag deployment has not occurred.

DTC B0052 becomes a latched code after 3 consecutive pretensioner deployments or 1 frontal or side air bag deployment. You cannot clear a latched code. Replace the SDM after following the instructions in the diagnostic table.

DIAGNOSTIC AIDS

IMPORTANT: The seat belt pretensioners may deploy for impacts that are not severe enough to warrant frontal or side air bag deployment. The SDM is capable of sustaining 3 pretensioner deployment events, or one frontal or side deployment event. After the maximum number of deployments has occurred, DTC B0052 sets and becomes a latched code, which cannot be cleared.

When DTC B0053 is accompanied by additional DTCs, other than B0052, repair the malfunction causing the other DTCs before replacing SDM.

CIRCUIT/SYSTEM VERIFICATION
1. Ignition OFF, inspect the vehicle for signs of inflator module or pretensioner deployment. Verify that the vehicle does not show any signs of inflator deployment.
- If the vehicle displays any signs of inflator deployment, refer to Repairs and Inspections Required After a Collision.
2. Use a scan tool to clear DTCs. Verify that DTC B0052 does not reset.
- If the DTC resets, replace the SDM.

REPAIR INSTRUCTIONS
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for SDM replacement, setup, and programming