Operation CHARM: Car repair manuals for everyone.

B2880



DTC B2880

Circuit Description
The driver position module (DPM) determines the position of the steering column based on inputs received from position sensor built into the tilt actuator. The DPM supplies a 5-volt reference and a ground to the sensor and monitors the column position via a tilt position signal circuit.

DTC Descriptor
This diagnostic procedure supports the following DTC:

DTC B2880 Tilt Position Sensor

Conditions for Running the DTC
DTC B1327 is not set as current.

Conditions for Setting the DTC
This DTC will set as current when the tilt actuator circuit voltage is less than 0.25 volt or greater than 4.75 volts for 2 seconds.

Action Taken When the DTC Sets
The DPM will not allow the affected motor to work during memory recall and/or easy exit operations. However, the motor will still operate for manual switch positioning.

Conditions for Clearing the DTC
This DTC will clear from current status when the voltage is greater than 0.25 volt or less than 4.75 volts for 2 seconds.

Step 1 - Step 8: