Displaying & Reading Trouble Codes

DIAGNOSTIC TROUBLE CODE (DTC) DISPLAYING

This vehicle is equipped with an on-board diagnostic display feature capable of displaying DTCs using the 3 indicators on the rear parking assist display. After the bulb check has been completed, the red outside indicator flashes to indicate a malfunction with the system. The module disables operation of the ultrasonic rear parking assist (URPA) system under this condition.

In order to enter the diagnostic mode, complete the following actions:
1. With the ignition turned OFF, short the rear parking assist diagnostic connector to ground while the vehicle is in PARK. Refer to Object Detection Component Views for the location of the rear parking assist diagnostic connector.
2. Turn the ignition ON.
3. Place your foot on the brake.
4. Shift the vehicle into REVERSE within 5 seconds.If the vehicle is not shifted into reverse within 5 seconds after turning the ignition ON, the diagnostic mode will still be initiated. However, a reverse input wiring fault will be registered as sequence #7 as shown in the Diagnostic Indicator table. Refer to Diagnostic Trouble Code (DTC) Clearing for specific steps on how to clear DTCs. After the reverse input wiring code is cleared, repeat the DTC displaying steps in order to enter the diagnostic mode. Clearing Trouble Codes




When the diagnostic mode is first entered, the rear parking assist display displays the amber outside indicator and the red outside indicator. Then the indicators on the rear parking assist display will display one or more of the sequences in the table to indicate where the fault exists within the rear parking assist system. Refer to Diagnostic Trouble Code (DTC) Clearing for the specific steps on how to clear diagnostic trouble codes. Clearing Trouble Codes