Headlamp Leveling Sensor Replacement - Rear

HEADLAMP LEVELING SENSOR REPLACEMENT - REAR

REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the right rear tire and wheel assembly.




3. Disconnect the electrical connector (2).
4. Disconnect the ball and socket (3) from vehicle.
5. Remove the bolt (1) from the sensor.
6. Remove the sensor from the vehicle.

INSTALLATION PROCEDURE




1. Position the sensor (3) to the vehicle.
2. Install the bolt (1) to secure the sensor (4) to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 9 N.m (80 lb in).

3. Install the ball and socket (3) to the sensor (4).
4. Connect the electrical connector (2) to the sensor (4).
5. Install the right tire and wheel assembly.
6. Lower the vehicle.