Floor Shift Control Replacement

Floor Shift Control Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the nut from the shift control linkage.
3. Disconnect the shift control linkage rod from the shift control assembly.
4. Lower the vehicle.





5. Remove the console trim plate (1).
6. Remove the shift control trim plate (2).
7. Remove the center console assembly.





8. Disconnect the electrical connector from the shift control assembly.
9. Remove the shift control mounting nuts.
10. Remove the shift control assembly from the vehicle.

Installation Procedure





1. Install the shift control assembly to the vehicle.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the 4 nuts securing the shift control assembly.
Tighten the nuts to 12 Nm (106 inch lbs.).
3. Connect the electrical connector to the shift control assembly.





4. Install the center console assembly.
5. Install the shift control trim plate (2).
6. Install the console trim plate (1).
7. Transfer the shift control knob from the old shifter to the new shifter.





8. Raise the vehicle. Refer to Vehicle Lifting.
9. Install the shift control linkage rod to the shift control assembly.
10. Install the shift control linkage adjustment nut finger tight.
11. Adjust the shift control linkage.