Seat Adjuster Replacement - Driver Side

Seat Adjuster Replacement - Driver Side

Removal Procedure

1. Remove the seat.
2. Remove the seat cushion cover.




3. Reposition the lumbar pump, if equipped.
Remove the tie straps and reposition the pump and pouch up through the seat support wires.
4. Disconnect the seat belt harness from the seat frame.
5. Remove the memory seat control module.




6. Remove the bolts mounting the seat to the adjuster.
7. Remove the adjuster.
8. Transfer parts as necessary.

Installation Procedure






Notice: Refer to Fastener Notice in Service Precautions.

1. Install the adjuster to the seat.

Tighten the bolts to 24 N.m (18 lb ft).




2. Install the lumbar pump, if equipped. Secure the pump to the torque tube with tie straps.
3. Connect the seat belt harness to the seat frame.
4. Install the memory seat control module.
5. Install the seat cushion cover.
6. Install the seat.
7. Calibrate the seat. Refer to Memory Seat Calibration Procedure.