Operation CHARM: Car repair manuals for everyone.

P0572



DTC P0572 (Standard)

Circuit Description

The electronic brake control module (EBCM) receives a signal from the brake pedal position (BPP) sensor through the BPP sensor signal circuit. The EBCM then applies a signal through the torque converter clutch (TCC)/brake/cruise control release switch signal circuit to the transmission control module (TCM) and engine control module (ECM).

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC P0572 Brake Switch Circuit 1 Low Voltage.

Conditions for Running the DTC

* The vehicle has cycled from 0-60 km/h (0-37 mph) 3 times in 1 ignition cycle.
* Continuous once the previous criteria have been met

Conditions for Setting the DTC

The TCM detects voltage on the TCC/brake/cruise control release switch signal circuit when the circuit should be open.

Action Taken When the DTC Sets

* The TCM stores the DTC information into memory when the diagnostic runs and fails.
* The malfunction indicator lamp (MIL) will not illuminate.
* The TCM records the operating conditions at the time the diagnostic fails. The TCM stores this information in the Failure Records.

Conditions for Clearing the DTC

* A last test failed, or current DTC, clears when the diagnostic runs and does not fail.
* A history DTC will clear after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
* Use a scan tool in order to clear the DTC.

Diagnostic Aids

Important:
* Verify that the BPP sensor is properly calibrated. Refer to Brake Pedal Position Sensor Calibration.
Programming and Relearning

* Test drive the vehicle if a switch or circuit condition cannot be located. An intermittent condition may be duplicated during a test drive.

* Thoroughly inspect the wiring and connectors. An incomplete inspection of the wiring and connectors may result in misdiagnosis causing part replacement with the reappearance of the malfunction. If an intermittent malfunction exists, refer to Testing for Intermittent Conditions and Poor Connections. Component Tests and General Diagnostics

TEST

Step 1 - Step 6: