Camshaft Position Actuator Solenoid Replacement - Bank 1 (Right Side) Intake

Camshaft Position Actuator Solenoid Replacement - Bank 1 (Right Side) Intake

Removal Procedure

1. Turn the ignition OFF.

Important: Do not remove the engine control module (ECM) from the ECM bracket.

Do not remove the ECM redundant ground wire from the ECM.

2. Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.




3. Remove the camshaft position (CMP) actuator valve electrical connector.




4. Remove the CMP actuator valve bolt.
5. Remove the CMP actuator valve.
6. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.

Installation Procedure

1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.




2. Install the CMP actuator valve.

Notice: Refer to Fastener Notice.

3. Install the CMP actuator valve bolt.

Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).




4. Install the CMP actuator valve electrical connector.
5. Install the ECM bracket with the ECM.