Exhaust Manifold Heat Shield Replacement - Left Side

Exhaust Manifold Heat Shield Replacement - Left Side (LP1, LY7)

Removal Procedure

Caution: Refer to Exhaust Service Caution.

Caution: Refer to Protective Goggles and Glove Caution.

1. Remove the intermediate steering shaft.




2. Remove the exhaust manifold heat shield upper bolts.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the exhaust manifold heat shield lower bolt.
5. Disconnect the center intermediate shaft from the lower intermediate shaft to provide a removal envelope for the shield.
6. Remove the exhaust manifold heat shield.




7. Remove the upper exhaust manifold heat shield insulator from the oil level indicator tube, if necessary.




8. Remove the lower exhaust manifold heat shield insulator from the oil level indicator and exhaust gasket, if necessary.

Installation Procedure




1. Install the lower exhaust manifold heat shield insulator to the oil level indicator and exhaust gasket, if necessary.




2. Install the upper exhaust manifold heat shield insulator to the oil level indicator tube, if necessary.




3. Install the exhaust manifold heat shield.
4. Install but do not tighten the exhaust manifold heat shield lower bolt.
5. Lower the vehicle.

Notice: Refer to Fastener Notice.

6. Install the exhaust manifold heat shield upper bolts.

Tighten the bolts to 10 N.m (89 lb in).

7. Raise and support the vehicle. Refer to Vehicle Lifting.
8. Tighten the exhaust manifold heat shield lower bolt.

Tighten the bolt to 10 N.m (89 lb in).

9. Install the center intermediate shaft to the lower intermediate shaft.
10. Lower the vehicle.