Aisin AY6 - Manual Transmission

Backup Lamp Switch Replacement

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the backup lamp switch electrical connector.
3. Using a 27 mm wrench, remove the backup lamp switch and washer (208) from the case. Discard the washer.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the backup lamp switch and a NEW washer (208) to the case.

Tighten the switch to 44 N.m (32 lb ft).

2. Connect the backup lamp switch electrical connector.
3. Lower the vehicle.