Operation CHARM: Car repair manuals for everyone.

Oil Filter: Service and Repair



Engine Oil and Oil Filter Replacement

Removal Procedure

1. Turn the ignition OFF.

Important: Use a 6-point socket to remove the oil filter cap.




2. Remove the oil filter cap.




3. Remove and discard the oil filter cartridge.
4. Raise and support the vehicle. Refer to Vehicle Lifting.
5. Place a suitable drain below the oil pan drain plug.




6. Remove the oil pan drain plug.
7. Allow the oil to drain completely.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the oil pan drain plug and NEW O-ring seal.

Tighten the oil pan drain plug to 20 N.m (15 lb ft).

2. Lower the vehicle.




3. Install the NEW oil filter cartridge.





Notice: Lubrication must be applied to the threads of the oil filter cap prior to installation. Failure to lubricate the oil filter cap threads can hinder later removal and cause possible oil filter cap damage.

4. Lubricate the oil filter cap threads with clean engine oil.





Notice: Proper oil filter cap tightening is mandatory. Failure to tighten the oil filter cap to the proper specification can hinder later removal and cause possible oil filter cap damage.

Important: Use a 6-point socket to install the oil filter cap.

5. Install the oil filter cap.

Tighten the oil filter cap to 25 N.m (18 lb ft).

6. Install the oil fill cap.
7. Fill the engine with the appropriate oil type and quantity. Refer to Fluid and Lubricant Recommendations and Capacities - Approximate Fluid.