Tie Rod: Service and Repair

Rack and Pinion Inner Tie Rod Replacement

Removal Procedure




1. Remove the rack and pinion boot.

Notice: The pipe wrench must be placed at the valve end of the steering gear and positioned up against the inner tie rod housing. Placing the pipe wrench in any other location will cause damage to the steering gear.

2. Place a pipe wrench on the rack (5) next to the inner tie rod housing (6).
3. Place a wrench on the flats of the inner tie rod housing (6).
4. Rotate the inner tie rod housing (6) counterclockwise, while holding the rack stationary, until the inner tie rod separates from the rack (5).

Assembly Procedure




1. Attach the inner tie rod onto the rack (3).

Notice: The pipe wrench must be placed at the valve end of the steering gear and positioned up against the inner tie rod housing. Placing the pipe wrench in any other location will cause damage to the steering gear.

2. Place a pipe wrench on the rack (3) next to the inner tie rod housing (2).

Notice: Refer to Fastener Notice.

3. Place a torque wrench and the J 34028 on the flats of the inner tie rod housing (2).

Tighten the inner tie rod to 100 N.m (74 lb ft).

4. Install the rack and pinion boot.