C0284
DTC C0284
Circuit Description
The brake pedal position (BPP) sensor is a potentiometer. The electronic brake control module (EBCM) supplies a 5-volt reference circuit and low reference circuit to the BPP sensor. The BPP sensor signal circuit is a direct input to the EBCM. The EBCM determines the BPP based on the voltage from the BPP sensor. The EBCM converts the brake pedal position sensor feed back voltage to a digital signal and puts it on the class 2 communication bus. If the voltage is greater than 4.9 volts, then DTC C0284 will set
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0284 Brake Pedal Position Sensor Circuit High
Conditions for Running the DTC
* The EBCM must be powered.
* This test is run continuously.
Conditions for Setting the DTC
The feedback voltage is greater than 4.9 volts for more than 610 milliseconds.
Action Taken When the DTC Sets
When DTC C0284 is set the following will occur:
* The engine drive control is disabled.
* The panic brake assist is disabled.
* The traction control system is disabled.
* The vehicle stability enhancement system is disabled.
* The service vehicle soon lamp will illuminate.
Conditions for Clearing the DTC
* The current DTC will clear when the fault is no longer present.
* A history DTC clears after 100 consecutive ignition cycles in which no faults have occurred.
* Clear the DTC with a scan tool.
TEST
