Door Lock Cylinder Replacement (with UA2)

Door Lock Cylinder Replacement (with UA2)

Removal Procedure




1. Place the window in the full up position.
2. Remove the door trim panel.
3. Pull the rear of the water deflector far enough away from the door in order to access the outside door handle. Refer to Front Side Door Water Deflector Replacement.
4. Remove the outside door handle.
5. Remove the E-clip (2) on the lock cylinder.
6. Remove the lock rod and arm.
7. Remove the roll pins (1).

1. Insert a suitable prying tool between the reinforcement (3) and the roll pin (1).
2. Pry the roll pin downward far enough to grasp the opposite end with pliers.
3. Remove the roll pin with the pliers.
4. Remove the remaining roll pin with a drift punch.

8. Remove the lock cylinder from the backside of the door handle.

Installation Procedure




1. If a new lock cylinder is to be installed, refer to Key and Lock Cylinder Coding for the proper coding procedure.
2. Insert the lock cylinder into the cavity in the door handle.




3. Install the roll pins (1).
4. Secure the lock cylinder arm and rod to the lock cylinder with the E-clip (2).
5. Install the outside door handle. Refer to Door Handle Replacement - Front Outside.
6. Install the water deflector. Refer to Front Side Door Water Deflector Replacement.
7. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement.