Operation CHARM: Car repair manuals for everyone.

143. Power Steering Pump Installation



Power Steering Pump Installation

Tools Required

J 25033-C Pulley Installer





Important: Follow the procedure sequence in order to prevent drive belt mis-alignment and/or possible damage/distortion to the components.

1. Place the power steering pump in position to the cylinder block.
2. Loosely install the power steering side bolts in order to hold the power steering pump in position.
3. Place the power steering front bracket in position.
4. Loosely install the power steering front bracket bolts.
5. Hold the power steering pump firmly against the engine block.

Notice: Refer to Fastener Notice.

6. Tighten the power steering pump front bracket bolt.

Tighten the power steering pump front bracket bolt to 50 N.m (37 lb ft).

7. Install the power steering pump side bolts.

Tighten the power steering pump side bolts to 50 N.m (37 lb ft).




8. If removed, install the power steering pump pulley using the J 25033-C.




9. Ensure that the axial tolerance of the power steering pulley on the power steering pump is within 0.25 mm (0.010 in).