16. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Tools Required

* EN 46106 Flywheel Holding Tool
* J 24420-C Harmonic Balancer Puller
* J 38416-2 Crankshaft Button




1. Install the EN 46106 through the starter mounting hole.




2. Remove the crankshaft balancer bolt.




3. Install the J 38416-2 in the nose of the crankshaft.




4. Install the J 24420-C in order to remove the crankshaft balancer.




5. Pull the crankshaft balancer off by tightening the center bolt on the J 24420-C until the crankshaft balancer pulls off of the crankshaft end.
6. Remove the J 24420-C from the crankshaft balancer.