Tremec 6-Speed - Manual Transmission

Backup Lamp Switch Replacement

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the backup lamp switch electrical connector (3).
3. Remove the backup lamp switch wire harness from the bracket.
4. Using a Snap-On(TM)VSM5222 22 mm angle head open end wrench, or equivalent, remove the backup lamp switch (2).

Installation Procedure




1. Apply pipe sealant with Teflon(R) to the threads of the backup lamp switch. Use GM P/N 1052080 or equivalent.

Notice: Refer to Fastener Notice.

2. Install the backup lamp switch (2).

The backup lamp switch to 27 N.m (20 lb ft).

3. Install the backup lamp switch wire harness to the bracket.
4. Connect the backup lamp switch electrical connector (3).
5. Lower the vehicle.