Rear Suspension

Wheel Stud Replacement

Tools Required

J 43631 Ball Joint Remover

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.




3. Remove the wheel bearing/hub assembly.
4. Using J 43631 remove the wheel stud from the wheel bearing.

Installation Procedure




1. Install the new stud from the back side of the hub.
2. Install flat washers on the wheel stud.

Important: Ensure that the wheel stud is fully seated against the wheel hub flange.

3. With the flat side of a wheel nut against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.
4. Install the wheel bearing/hub assembly.
5. Install the tire and wheel.
6. Lower the vehicle.