Windows: Adjustments
Door Window Adjustment
Caution: Refer to Glass and Sheet Metal Handling Caution.
Caution: Refer to Express Window Down Caution.
1. Remove the door trim panel.
2. Pull down the upper portion of the water deflector far enough to access the window clamp nuts. Refer to Front Side Door Water Deflector Replacement or Rear Side Door Water Deflector Replacement.
3. Loosen the window regulator to window clamp nuts 4 revolutions.
4. Connect the door trim panel wire connector.
Important: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
5. Start the vehicle.
Notice: Refer to Fastener Notice.
6. Using the power window switch, raise the window to the full up position.
Tighten the window clamp nuts to 11 N.m (98 lb in).
7. Inspect for proper window operation and a tight seal.
8. Shut off the vehicle.
9. Install the water deflector.
10. Install the door trim panel.