Valve Rocker Arm Cover Replacement - Left Side

Valve Rocker Arm Cover Replacement - Left Side

Removal Procedure




1. Remove the engine sight shield.




2. Remove the ignition coil assembly.




3. Loosen the valve rocker arm cover bolts.
4. Remove the valve rocker cover.




5. Remove and discard the rocker cover gasket (1).
6. Clean and inspect the rocker arm cover.

Installation Procedure

Important:

* All gasket surfaces should be free of oil and other foreign material during assembly.

* DO NOT reuse the valve rocker arm cover gasket.

* The valve rocker arm cover bolt grommets may be reused.




1. Install a NEW rocker cover gasket (1) into the valve rocker cover lip.




2. Install the valve rocker arm cover.

Notice: Refer to Fastener Notice.

3. Tighten the valve rocker cover bolts.

Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).




4. Install the ignition coil assembly.




5. Install the engine sight shield.