Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure




1. Remove the engine sight shield.
2. Disconnect the oil pressure sensor electrical connector (2).

Important: Clean the area around the sensor before removal. This avoids debris from entering the engine.

3. Remove the oil pressure sensor from the engine block.

Installation Procedure




1. If installing the old sensor, apply thread sealant to the threads. Refer to Sealers, Adhesives, and Lubricants.

Notice: Refer to Fastener Notice.

2. Install the oil pressure sensor to the engine block.

Tighten the engine oil pressure sensor to 35 N.m (26 lb ft).

3. Connect the oil pressure sensor electrical connector (2).
4. Install the engine sight shield.