B2595
DTC B2595
DTC Descriptor
DTC B2595 00
- Right Cornering Lamp Control Circuit
Diagnostic Fault Information
Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
Circuit/System Description
Voltage is applied at all times to the right cornering lamps relay which is part of the underhood electrical center. When the park lamp switch is placed in the ON position, ground is applied to the body control module (BCM) through the park lamp switch circuit. The BCM then applies a ground to the left and right cornering lamp control circuits. This engages the cornering lamp relays and applies voltage through the left and right cornering lamp fuses to the cornering lamps.
Conditions for Running the DTC
The ignition is ON. Park lamps must be ON and the cornering lamps must be commanded ON.
Conditions for Setting the DTC
The BCM detects a short to voltage on the right cornering lamp control circuit while trying to apply a ground to the circuit.
Action Taken When the DTC Sets
The right cornering lamp does not illuminate.
Conditions for Clearing the DTC
The BCM clears this code from current when the fault is removed from the system.
Circuit/System Verification
Ignition ON, turn the park lamps ON. The cornering lamps should illuminate.
Circuit/System Testing
1. Clear the DTC. Park lamp switch OFF, disconnect the BCM. Using a test lamp connected to ground, probe the right cornering lamp control circuit. Verify the test lamp illuminates.
• If the test lamp does not illuminate, replace the BCM.
2. Test for a short to voltage in the right cornering lamp control circuit.
• If all circuits/connections test normal, replace the underhood electrical center.
Repair Instructions
Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.
* Underhood Electrical Center or Junction Block Replacement
* Programming and Relearning for BCM setup, and programming. Programming and Relearning