B2860
DTC B2860
Circuit Description
The steering column module determines the position of the steering column based on inputs received from the position sensor, built into the telescoping actuator. The steering column module supplies a 5-volt reference and a ground to the sensor and monitors the column position via a telescope position signal circuit.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1860 Telescope Position Sensor
Conditions for Running the DTC
DTC B1327 is not set as current.
Conditions for Setting the DTC
This DTC will set as current when the voltage is greater than 4.8 volts for 2 seconds on the telescoping actuator.
Action Taken When the DTC Sets
The steering column module will not allow the affected motor to work during memory recall and/or easy exit operations. However, the motor will still operate for manual switch positioning.
Conditions for Clearing the DTC
This DTC will clear from current status when the voltage is less than 4.8 volts for 2 seconds.
Diagnostic Aids
Inspect the steering column for abnormal looseness.
