Symptom 01
DTC B2880 (Symptom 01)
Circuit Description
The driver position module (DPM) determines the position of the steering column based on inputs received from a position sensor built into the tilt actuator. The DPM supplies a 5 volt reference and a ground to the sensor and monitors the column position via the tilt sensor signal circuit. If the tilt sensor signal circuit is shorted to voltage, DTC B2880 01 will set.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B2880 Tilt Position Sensor
This vehicle has DTCs which include DTC symptoms. For more information on DTC symptoms, refer to DTC Symptom Description.
Conditions for Running the DTC
DTC B1327 is not set as current.
Conditions for Setting the DTC
This DTC will set as current when the voltage is greater than 4.8 volts for 2 seconds on the tilt sensor signal circuit.
Action Taken When the DTC Sets
The DPM will not allow the tilt motor to work during memory recall and/or easy exit operations. However, the motor will still operate for manual switch positioning.
Conditions for Clearing the DTC
This DTC will clear from current status when the voltage is less than 4.8 volts for 2 seconds.
