Symptom 5A
DTC B2880 (Symptom 5A)
Circuit Description
The driver position module (DPM) determines the position of the steering column based on inputs received from position sensors built into the tilt actuator. The DPM supplies a 5-volt reference and a ground to the sensor and monitors the column position via the tilt sensor signal circuit. The DPM expects the voltage on the tilt sensor signal circuit to be within a certain range of what the voltage was previously. If the voltage on the tilt sensor circuit changes by a large amount in a short time, DTC B2880 5A may set.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B2880 Tilt Position Sensor
This vehicle has DTCs which include DTC symptoms. For more information on DTC symptoms, refer to DTC Symptom Description.
Conditions for Running the DTC
DTC B1327 is not set as current.
Conditions for Setting the DTC
This DTC will set as current if voltage on the tilt signal circuit is outside of the expected range.
Action Taken When the DTC Sets
The steering column module will not allow the affected motor to work during memory recall and/or easy exit operations. However, the motor will still operate for manual switch positioning.
Conditions for Clearing the DTC
This DTC will clear from current status when the voltage on the tilt signal circuit remains within the expected range.
