P2763
DTC P2763
Circuit Description
The ignition voltage is provided to the torque converter clutch pulse width modulated (TCC PWM) solenoid valve. The transmission control module (TCM) controls the ON and OFF time of the TCC PWM solenoid by controlling the ground side of the TCC solenoid valve control circuit. The TCM uses a PWM duty cycle, in order to control application and release of the TCC. When the solenoid is commanded OFF, the TCM senses high voltage. When the solenoid is commanded ON, the TCM senses low voltage.
When the TCM detects a short to voltage in the TCC Solenoid valve control circuit, then DTC P2763 sets. DTC P2763 is a type B DTC.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P2763 Torque Converter Clutch (TCC) Pressure Control (PC) Solenoid Control Circuit High Voltage
Conditions for Running the DTC
* The engine run time is greater than 5 seconds.
* TCC is commanded ON.
Conditions for Setting the DTC
DTC P2763 sets when the TCM detects a short to voltage in the TCC PWM solenoid valve circuit.
Action Taken When the DTC Sets
* The TCM requests the engine control module (ECM) to illuminate the malfunction indicator lamp (MIL) during the second consecutive trip in which the Conditions for Setting the DTC are met.
* The TCM commands maximum line pressure.
* The TCM forces TCC OFF.
* The TCM inhibits TCC solenoid.
* The TCM inhibits fourth gear if the transmission is in Hot Mode.
* The TCM freezes transmission adaptive function.
* The ECM records the operating conditions when the Conditions for Setting the DTC are met. The ECM stores this information as Freeze Frame and Failure Records and the TCM records the operating conditions when the Conditions for Setting the DTC are met. The TCM stores this information as Failure Records.
* The TCM stores DTC P2763 in TCM history.
Conditions for Clearing the MIL/DTC
* The ECM turns OFF the MIL after the third consecutive drive trip in which the TCM does not send a MIL illumination request.
* The TCM clears the DIC message when the condition no longer exists.
* A scan tool can clear the MIL/DTC.
* The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without an emission related diagnostic fault occurring.
* The TCM cancels the default actions when the ignition is OFF long enough in order to power down the TCM.
Test Description
The number below refers to the step number on the diagnostic table.
3. This step tests the TCM and the wiring to the transmission.
5. This step verifies that the circuit has the correct resistance.
