Wheel Bearing/Hub Replacement - Rear (FE1, FE3)

Wheel Bearing/Hub Replacement - Rear (FE1, FE3)

Removal Procedure

1. Raise and support the vehicle. Refer to vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake rotor.




4. Disconnect the ABS sensor wire connector.




5. Remove the wheel bearing/hub bolts.
6. Remove the wheel bearing/hub and brake shield.

Installation Procedure




1. Clean the lower control arm face and bore before installing the wheel bearing and hub.
2. Install the wheel bearing and hub and brake shield to the lower control arm.

Notice: Refer to Fastener Notice.

3. Install the wheel bearing and hub retaining bolts.

Tighten the wheel bearing and hub retaining bolts to 68 N.m (50 lb ft).

4. Install the brake rotor.




5. Install the ABS sensor wire connector.
6. Install the tire and wheel.
7. Lower the vehicle.