Rear Suspension

Wheel Stud Replacement

Tools Required

J 35917 Ball Joint Remover

Removal Procedure

1. Raise and support the vehicle. Refer to vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake rotor.




4. Using the J 35917, remove the wheel stud at the inner most notch in the knuckle on the caliper side of the steering knuckle.

Installation Procedure




1. Install the new wheel stud.
2. Using washers and a wheel nut, pull the wheel stud in position.
3. Install the brake rotor.

Notice: Refer to Fastener Notice.

4. Install the brake caliper and bolts.
5. Install the wheel and the tire.
6. Lower the vehicle.