Negative: Service and Repair

Battery Negative Cable Replacement

Removal Procedure

Important:
* Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.

* Always route the replacement cable the same way as the original cable.




1. Disconnect the negative battery cable.
2. Disconnect the body harness electrical connector from the negative battery cable electrical connector.
3. Disconnect the body harness electrical connector from the battery current sensor.
4. Remove the negative battery cable ground bolt.
5. Remove the negative battery cable.

Installation Procedure

Important: When installing the negative battery cable, ensure that the cable eyelet is installed with the flat side down. Keep the crimped side facing upward.




1. Place the negative battery cable eyelet over the hole in the floor pan.

Notice: Refer to Fastener Notice.

2. Install the negative battery cable ground bolt.

Tighten the bolt to 36 N.m (27 lb ft).

3. Connect the body harness electrical connector to the battery current sensor.
4. Connect the body harness electrical connector to the negative battery cable electrical connector.
5. Connect the negative battery cable.