Rack and Pinion Outer Tie Rod End Replacement

Rack and Pinion Outer Tie Rod End Replacement

Removal Procedure

Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

1. Raise and support the vehicle. Refer to vehicle Lifting.
2. Remove the tire and wheel.




3. Remove the outer tie rod retaining nut (2).




4. Loosen the jam nut (2) on the inner tie rod (1).




5. Using J 24319-B remove the outer tie rod from the steering knuckle.




6. Remove the outer tie rod (3) from the inner tie rod (1).

Installation Procedure




1. Install the outer tie rod (3) to the inner tie rod (1).
2. Do not tighten the jam nut (2).




3. Install the outer tie rod (2) to the steering knuckle (1).





Notice: Refer to Fastener Notice.

4. Install the outer tie rod retaining nut (2).
^ Tighten the outer tie rod retaining nut (2) to 47 N.m (35 lb ft).
^ Tighten the outer tie rod retaining nut (2) up to 1/6 additional turn, or 70 N.m (52 lb ft) maximum.
5. Install the tire and wheel.
6. Lower the vehicle.

Important: Ensure that the rack and pinion boot is not twisted or puckered during toe adjustment.

7. Adjust the front toe. Refer to Front Toe Adjustment.