U0415
DTC U0415
Circuit Description
The electronic brake control module (EBCM) sends antilock brake system (ABS) data to the engine control module (ECM). The data is sent to the ECM through a communication network called the GM local area network (LAN). Two circuits are used to communicate LAN data between the ECM and EBCM. A fault in the LAN will not cause DTC U0415 to set by itself. If a LAN fault occurs, other DTCs will set in addition to DTC U0415.
If the ECM receives invalid antilock brake system data from the EBCM, this DTC sets.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC U0415 EBCM Communication Circuit Performance
Conditions for Running the DTC
* The ignition is on for more than 3 seconds.
* The ignition 1 voltage is between 10.5-18 volts.
* No other communication errors are present.
* DTC U0415 runs continuously once the above conditions are met.
Conditions for Setting the DTC
The ECM receives no valid antilock brake system data from the EBCM for more than 1 second.
Action Taken When the DTC Sets
* The control module stores the DTC information into memory when the diagnostic runs and fails.
* The malfunction indicator lamp (MIL) will not illuminate.
* The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
* The driver information center, if equipped, may display a message.
Conditions for Clearing the DTC
* A current DTC Last Test Failed clears when the diagnostic runs and passes.
* A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
* Clear the DTC with a scan tool.
Test