Barometric Pressure Sensor: Service and Repair

Barometric Pressure Sensor Replacement

Removal Procedure




1. Turn the ignition OFF.
2. Remove the fuel injector sight shield.
3. Disconnect the barometric pressure (BARO) sensor electrical connector.




4. Remove the BARO sensor bolt.
5. Remove the BARO sensor.

Installation Procedure




1. Install the BARO sensor.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the BARO sensor bolt.

Tighten the sensor bolt to 10 N.m (89 lb in).




3. Connect the BARO sensor electrical connector.
4. Install the fuel injector sight shield.